MXH 60 Pneumatic Linear Actuator

Image of MXH 60 Pneumatic Actuator The MXH Series linear actuator features a design utilizing an internal pneumatic drive for movement.  The body is constructed from an anodized aluminum profile and is corrosion resistant; allowing this unit to operate in severe environments.  The linear actuator’s outer surfaces are precision extruded, providing for flush mounting on both sides and the base to facilitate a qualified, clean and easy installation.  T-slots along its full length on both sides allow for the unit to be mounted in numerous orientations with ease and for ancillary items; such as sensors, to be mounted directly to its body.

Linear motion is provided by an internal air cylinder with a Ø40 mm (Ø1.57 in) piston.  A thrust force of 754 N (169.5 lbf) can be generated with 6 bar (87 PSI).  Pneumatics provide for high speed, moderate force and high acceleration while maintaining accurate positioning.

Linear guidance is through cam roller bearings integrated on the carriage which run on hardened and ground profile rails.  The profile rail and bearing design provide high rigidity, accuracy and speed with low friction, noise and vibration for the carriage.

The MXH linear actuator excels in harsh environments of several different industries. Food and Beverage, vertical applications, pick and place, packaging, automotive, and medical are all examples where the MXH actuator has a proven track record.

Features include:

Performance

  • Stroke lengths up to 5 m (196 in)
  • Maximum single carriage loads up to 2200 N (495 lbf)
  • Maximum moments up to 400 Nm (295 lb•ft)
  • Speeds up to 5 m/s (196 in./s)
  • Repeatability ± 0.05 mm (± 0.002 in)

Anodized Aluminum Housing & Carriage

  • Anodized aluminum body with integrated pneumatic drive:
    • Size 60 = 60 mm x 70 mm (2.36 in x 2.75 in)
  • Fully enclosed housing with integrated round guide rails
  • Precision extruded profile—precision mounting surfaces on sides and bottom
  • Corrosion resistant
  • Can be used as part of a system structural component

Cam Roller Guided Rail system

  • Angular contact ball bearing Cam Rollers
  • Hardened and ground profile rail
  • High rigidity and accuracy
  • Low friction and high speed
  • Low noise and vibration

Pneumatic (air) Driven

  • Ø40 mm (Ø1.57 in) piston – internal to body
  • Thrust of 754 N (169.5 lbf) @ 6 bar (87 PSI)
  • High repeatable positioning
  • Long travel length
  • Low maintenance

T-slots for mounting

  • Integrated in housing for fixing ease and compactness
  • Integrated in carriage for fixture or plate mounting
  • Direct sensor mounting on body

Accessories & Additional Options

  • Actuator mounting clamps
  • Limit switches & brackets
  • Several carriage options
  • Extended length carriage
  • Cable carrier

PBC Linear | 6402 Rockton Road, Roscoe, IL 61073 | P. O. Box 6980, Rockford, IL 61125-6980 | Toll-Free (888) 389-6266 | Fax: (815) 389-5790
 

You can leave a response, or trackback from your own site.

Leave a Reply

You must be logged in to post a comment.

Powered by WordPress | Designed by: Virtual Dedicated Servers | Compare Top WordPress Themes, wordpress 4 themes and